ResMed AirFit P10 User Manual page 9

CAUTION
•
If any visible deterioration of a system component is apparent
(cracking, crazing, tears etc), the component should be discarded
and replaced.
•
Avoid connecting flexible PVC products (eg, PVC tubing) directly
to any part of the mask. Flexible PVC contains elements that can
be detrimental to the materials of the mask, and may cause the
components to crack or break.
•
If your headgear comes with a buckle, do not overtighten the
headgear when fitting the mask as this may lead to skin redness
or sores around the mask cushion.
•
Do not iron the headgear as the material is heat sensitive and will
be damaged.
Daily/After each use:
•
Disassemble the pillows from the frame according to the disassembly
instructions.
•
Thoroughly clean the separated mask components (excluding
headgear), by gently rubbing in warm (approximately 86°F/30°C) water
using mild soap.
•
To optimize the mask seal, facial oils should be removed from the
pillows after use.
•
Use a soft bristle brush to clean the vent.
•
Inspect each component and, if required, repeat washing until visually
clean.
•
Rinse all components well with drinking quality water and allow to air
dry out of direct sunlight.
•
When all components including the vent are dry, reassemble
according to the reassembly instructions.
Weekly:
•
Soak the headgear in warm water with a mild liquid detergent.
•
Hand wash the headgear with a soft bristle brush.
•
Thoroughly rinse the headgear under running water.
•
Leave the headgear to air dry out of direct sunlight.
English 5