ResMed AirFit P10 User Manual page 7

For a full list of compatible devices for this mask, see the Mask/Device
Compatibility List at ResMed.com/downloads/masks.
Notes:
•
This mask is not compatible for use with ResMed AutoSet CS™ 2 and
VPAP™ Adapt SV devices.
•
SmartStart may not operate effectively when using this mask with
some CPAP or bilevel devices that have this feature.
•
If you experience nasal dryness or irritation, using a humidifier is
recommended.
Fitting
1. Hold the pillows away from your nose ensuring that the pillow size
(eg, M) with the left (L) and right (R) indicators are correctly facing
towards you then guide the nasal pillows into your nostrils (L into your
left nostril, R into your right nostril). Pull the headgear over your head
by holding the bottom band and stretching it around the back of your
head. The top band should sit comfortably on top of your head.
Tip! There are raised logos on top of the frame so you can feel the
correct way up when fitting in the dark.
2. Move the mask away from your face then place it back to get a
comfortable fit. Ensure the nasal pillows fit securely into your nostrils
with both pillows positioned upright.
3. Finally, connect the end of the mask tubing into your device air tubing.
Your mask is now fitted and ready to use. When the device is running,
a light breeze should be felt through the vent. To inspect the vent
place a finger close but not over the entire vent area.
Adjustment
•
To achieve a comfortable fit, adjust the split bands by spreading them
apart to loosen or draw them closer together to tighten.
•
If your headgear comes with a buckle, adjust the headgear by pulling
the headgear through the buckle to fix mask leaks. Adjust only enough
for a comfortable seal and do not overtighten. You may need to adjust
the headgear as it stretches over time.
English 3