Before Asking For Repair Services - Luxman L-595ASE Owner's Manual

Before Asking for Repair Services

While in use, this unit may display phenomena which may be confused as malfunctions. Before contacting your country's official
LUXMAN distributor for repair services, please read the operating instructions for any connected input and output devices and check
the troubleshooting table below. If the cause of the malfunction cannot be identified, please contact your dealer. After LUXMAN's rep-
resentatives have accepted your request for repair services, inspection fees and transportation expenses may be claimed, even though
the unit may be found to be operating normally.
Problem
No power is supplied even
though the operation button is
pressed.
No sound is generated.
No sound is generated on one
side.
Humming sound is generated.
No effect of tone control or
balance control is observed.
The subsonic, monaural or
loudness is not activated.
The separate button of the
remote control is not activated.
Cause
• The power plug is disconnected from the
wall outlet, or it is not inserted correctly.
• The power plug is disconnected from the
AC inlet, or it is not inserted completely.
• The volume control is set to the minimum
level.
• The source to be reproduced is not selected
with the input selector.
• Cable connections are incomplete.
• The output level of the input device is set to
the minimum position.
• The separate button is set to on.
• The mute button of the remote control is set
to on.
• The balance control is fully rotated.
• Cables are not connected on one side.
• The ground side of an RCA cable has no
contact with the terminal.
• The ground wire of the analog player is not
connected.
• Connections or mounting conditions are
incomplete between the cartridge and shell,
or between the shell and tone arm of the
analog player.
• The line straight button is set to on.
• The line straight button is set to on.
• To prevent incorrect operations, this unit
is designed to toggle the separate on/off
by holding down the separate button for
approximately 1 second.
INTEGRATED AMPLIFIER L-595ASE
Solution
• Insert the power plug in the wall outlet
completely.
• Securely insert the power plug in the AC
inlet.
• Rotate the volume control clockwise to
adjust the sound volume.
• Select the source to be reproduced with
the input selector.
• Secure cable connections.
• Adjust the output level.
• Set the separate button to off.
• Set the mute button to off.
• The balance control should be set to the
center position under normal conditions.
• Secure cable connections.
• Secure connections so that the ground side
of the RCA cable can be connected.
• Connect the ground wire of the analog
player to the GND terminal.
• Connect (or mount) the cartridge, shell, and
tone arm correctly.
• When tone control or balance control are
used, the line straight button should be set
to off.
• When the subsonic, monaural or loudness
is used, the line straight button should be
set to off.
• Hold down the separate button of the
remote control for approximately 1 second.
Or turn on and off with the separate button
on the main unit.
21