SMA STORAGE-67-TS-10 Nstallation And Operating Instructions page 26

Table of Contents

26 INSTALLATION

Only for master/slave systems: Run the CAN bus cabling between the "CAN OUT"

connections

specifications in section "5.5 Battery module wiring" on page 17 et seq. Use the patch cable(s)

scope of delivery of the slave storage system.

Finally, fill out the commissioning protocol. you will find a template for this on the TESVOLT USB drive

document the serial numbers of the battery inverter and the peripheral devices such as the

SMA Inverter Manager. Send the completed commissioning protocol to the SMA Service center.

Use cable ties to fasten the cabinet connecting cables in the bottom

part of the cabinet to the cable clamp rails

Ensure that the cables are not crushed or damaged in the process.

Use patch cables

SMA HV APU to one of the two switches supplied

labeled "LAN." This switch is connected to the "LAN-2" jack of the

SMA Inverter Manager and will henceforth be referred to the "LAN-2

switch." The STPS 60-10 will also still be connected to it (see section "7

Connection to the Sunny Tripower Storage 60" on page 28 et seq.).

on the APUs of the storage systems in the master/slave configuration in accordance with the

1 .5

to connect the LAN connection point

7 .4

of the

via the jack

and "CAN IN"

from the

7 .4

. Also

Table of Contents