SMA STORAGE-67-TS-10 Nstallation And Operating Instructions page 23

10
11
12
13
14
© SMA Solar Technology AG Subject to changes to the technical content! Version 1.1 Last updated 04/2021
When connecting all DC connecting cables, note that the battery mod-
ules of the STORAGE-67-TS-10 are connected in series. It is essential
that the colors of the plugs match the colors of the sockets on the bat-
tery module, i.e. red plug to red jack, for example. The plugs must
audibly click into place. Start on the left side of the cabinet with the
APU, the first battery module and the connecting cable
Then, connect the remaining battery modules in this half of the cabinet
to the DC connecting cables
Connect the bottom two battery modules using the long DC connecting
cable from the cabinet connector set
6 . 1
Install the remaining DC connecting cables
on the right side. Start with the bottom module.
Connect the last module and the SMA HV APU using the connecting
cable . Be certain to follow the instructions in section "5.5 Battery
4 .2
module wiring" on page 17.
INSTALLATION
4 . 1
.
5 . 1
6
.
between the modules
5 . 1
23
.