Kruger AIRSEC 3000 Manual page 18

10
Direct water drainage
If required, the water removed from the air
can also be drained directly away.
Remove the water collecting bucket ( )
Knock out the prepared plastic part ( ) on
the left-hand side of the ap pli ance
Introduce a hose (available from trade out-
lets, inside diameter
new opening and push over the end of the
outlet pipe
Ensuring that a steep gradient is main-
tained, lead the other end of the hose into
a discharge pipe. Ensure that no water can
run back into the appli ance and water flow
is not obstructed in the hose.
Re-insert the water bucket
Cleaning
The cooling unit is hermetically sealed; the
fan bearings are permanently lubri cated and
therefore require no mainten ance.
mm) through the
Remove the mains plug from the wall
socket.
Wipe the housing with a soft, dry cloth. In
the case of light soiling use a damp cloth
with a mild cleaning agent.
Grip the air filter frame ( ) at the indent
and pull out.
Remove any dust and lint from the white
filter mesh with a brush or vac uum cleaner
(every – weeks).
Re-insert the filter and filter frame into
the appliance.
Re-insert the mains plug into the wall socket.
Heavy soiling will require the inside of the
appliance to be cleaned. This main ten ance
must be carried out by a refrig eration specialist.
Troubleshooting
Please check the following points before
taking the appliance to your specialist retailer:
A. The appliance does not operate
Has the mains plug been inserted cor-
rectly?
Is the fuse in your electrical switchbox
OK?
Is the mains cable and/or any ex ten sion
cord being used in good working condi-
tion?
Is the water collecting bucket empty?
Has the water collecting bucket been
replaced correctly?
Is the room humidity level above that set
on the appliance?
Have you waited three minutes before
attempting to switch on your appli-
ance again? The dehumidifier is fitted
with compressor protection. After being
switched o , the compressor can only
be re-started after an idle period of
minutes.