Table of Contents
Advertisement
Available languages
Available languages
System description
A fan is used to draw the moist room air
across the refrigeratory attached to the
cooling unit. The moisture condenses on the
evaporator coils and drips o as water into
the collecting bucket. Before leaving the unit,
the air is re-heated to the inlet temperature
by the condenser.
Useage instructions
Transport/Storage
Whenever possible, the appliance should
be transported in an upright position. After
being transported on its side, the appliance
must be stood in an upright position for at
least two hours before connection to the
mains and operation.
Before putting the appliance into storage if
it is not required for an extended period, the
water bucket must be removed and the appli-
ance must be cleaned with a damp cloth and
then wiped dry. The appliance should then be
packed away (original carton).
Installation
Place the dehumidifier on level ground.
Ensure that air in the room can circulate
freely.
Do not obstruct the inlet or outlet vents.
Maintain a safety zone of cm from any
flammable parts.
Place the dehumidifier at least
walls and furnishings.
Heed the maximum room size of
Operating temperatures: Mini mum +
/ maximum +
°C.
Operation
Close all windows and doors.
Insert the mains plug into a wall socket –
the pilot light ( ) will illuminate.
Open the air outlet flap at the top of the
appliance – IMPORTANT: The appliance
must not be operated with a closed flap.
Check to see whether the water collecting
bucket ( ) is correctly positioned.
Turn the hygrostat dial ( ) to the desired
position (generally the «B» position).
The dehumidifier will operate automat-ically,
i.e. it will switch itself o as soon as the set
degree of dryness has been reached, and will
only switch itself on again with rising humid-
ity. It is recommended that a hygrometer is
hung up in the room to check on moisture
levels. If room humidity levels are excessive,
turn the hygrostat dial on the appliance to a
lower setting, conversely, if humidity levels
are too low, select a higher setting on the de-
humidifier. If the hygrostat dial is set to «C»,
the appliance will operate continuously.
During the defrosting stage – shown by an il-
luminated defrost light ( ) – the compressor
will be switched o , however the fan will con-
tinue to operate.
Maintenance
The appliance will switch itself o automati-
cally when the water bucket ( ) is full. This
shutdown will also be indicated by the illumi-
nation of the centre pilot light ( ).
Grasp the bucket by the handle grips on
the left and right-hand sides and remove
cm from
the bucket carefully.
Empty the bucket.
m .
Replace the bucket in its proper position.
°C
Advertisement
Table of Contents
