Important Note To The Owner; Important Note To The Servicer; Transportation Damage; Unpacking The Unit - Gree GAA07AA-D3RNA2C Owner's Manual

SAFETY PRECAUTIONS

IMPORTANT NOTE TO THE OWNER

This equipment is to be serviced by professionally trained
personnel only. If this equipment is improperly installed,
adjusted or altered by an unqualified person, a safety
hazard may result.

IMPORTANT NOTE TO THE SERVICER

Read this manual and familiarize yourself with the specific
items which must be adhered to before attempting to
service this unit. The precautions listed in this manual
should not supersede existing practices but should be
considered as supplemental information.

TRANSPORTATION DAMAGE

All units are securely packed in shipping containers
approved by the National Safe Transit Association.The
carton should be checked upon arrival for external
damage. If damage is found, immediately make a written
request for inspection by the carrier's agent.
In the event of damage:
1. Note on the delivery receipt any visible damage to
shipment or container.
2. Notify carrier promptly and request an inspection.
3. File the claim with the following supporting documents
within the six month statute of limitations.
a. Original Bill of Lading, certified copy, or indemnity
bond.
b. Original paid freight bill or indemnity.
c. Original invoice or certified copy, showing trade and
other discounts or reductions.
d. Copy of the inspection report issued by carrier's
representative at the time damage is reported to the
carrier.
The carrier is responsible for making prompt inspection of
damage and for a thorough investigation of each claim.
The distributor or manufacturer will not accept claims from
dealers for transportation damage.

UNPACKING THE UNIT

1. Cut the carton banding and open the carton.
2. Remove the literature, hardware pack, upper styrofoam
shipping blocks, and styrofoam corner posts.
3. Remove the front assembly.
4. Lift the unit from the remaining carton.
5. Dispose of the cardboard and styrofoam at an approved
Recycle Center. Check all contents for damaged or
missing parts. In case of concealed damage, notify the
carrier as soon as possible—preferably within 5 days.
Refer to step 3 of the Transportation Damage section if
damage or missing parts are noted.

OPERATING INSTRUCTIONS

Check the data specification plate and ensure the proper
voltage and current rating for the type of power plug on the
unit is available. DO NOT REMOVE THE GROUNDING
PRONG FROM THE POWER CORD.See Figure 1 for the
types of acceptable plugs. Do not use an extension cord
for the installation of this product. Refer to the data
specification plate for electrical requirements.
120V
15 amp
LCDI or AFCI Power Cords - Underwrites Laboratories LCDI or AFCI Power Cords - Underwrites Laboratories
and the National Electric Code (NEC) now require and the National Electric Code (NEC) now require
power cords that sense current leakage and can open power cords that sense current leakage and can open
the electrical circuit to the unit on units rated at 250 the electrical circuit to the unit on units rated at 250
volts or less. In the event that unit does not operate, volts or less. In the event that unit does not operate,
check the reset button located on or near the head of check the reset button located on or near the head of
the power cord as part of the normal troubleshooting the power cord as part of the normal troubleshooting
procedure procedure
Note: Plug may be different with the actual product.Please
refer to actual product.
VOLTAGE MEASUREMENTS
Before connecting the unit, measure the supply voltage.
Voltage must fall within the voltage utilization range given
in Table 1.
Operating Voltage
Unit Voltage
Rating
230/208
115
Operating Voltage
4
240V
240V
13 amp
18 amp
Figure 1
LCDI power Cord
Voltage Utilization Range
Minimum Maximum
187 253
Table 1
103 126