1
Figure 8. Using the cable management tray
Note: If you have any unused embedded Fibre Channel ports, you should set them offline by using
the following command:
fcadmin config -t unconfig <adapter_name>
2. Connect the RJ-45 to DB-9 adapter from the adapter kit to the console port on the system.
e0a
e0b
3. Connect one end of the serial null modem cable to your console, and then connect the other end to
the DB-9 end of the adapter.
e0a
e0b
2
0a
0b
!
0a
0b
!
3
4
5
0c
0d
0c
0d
Installation and setup instructions
9