Dimplex CAS500 Manual page 19

Setting the Date and Time for the First Time
When first setting up the remote control, you will be presented with the time and date set up screen before you can begin
to use the remote control. Follow the steps below to set up the time and date for the remote control. (Note, the time on
the remote control will be represented in the 24-hour clock format and cannot be changed.)
1. Press and hold 'Button 6 - Enter' on the remote until the '00:00' is shown on the display (Fig A).
2. The first '0' of the time will be flashing. Using 'Button 5 - Arrows', navigate to the correct number for the first digit of
the current time. When the correct number is flashing on the display, press 'Button 6 - Enter'.
3. Once the first digit of the time has been set, the second '0' of the time will begin to flash. Navigate to the correct
number for the second digit of the time. When the correct number is flashing on the display, press 'Button 6 - Enter'.
(Note, if an incorrect number is selected for a particular time digit, press 'Button 2 - Back' to return to the previous
digit).
4. Complete the same steps for the third and four digits of the time.
5. Once the time is set, you will be presented with the menu to set the correct date (Fig B).
6. 'Day' will flash on the screen for two seconds and then you will be presented with the default day figure of '01'. Using
the same process as above, navigate and select the correct number corresponding to the first digit of today's day
number in the calendar month (eg. '3' for the 30th day of the month).
7. Complete the same steps for the second digit of today's day number in the calendar month (eg '0' for the 30th day
of the month).
8. Once the day has been set, you will be presented with the menu to set the correct month (Fig C).
9. '1 – 12' will flash on the screen for two seconds and you will then be presented with the default month figure of '01'.
Using the same process as above, navigate and select the correct number corresponding to the first digit of the
current month number (eg. '0' for January to September and '1' for October to December).
10. Once the day and month are set, 'Year' will flash for two seconds and you will be presented with the menu to set
the correct year (Fig D).
11. Select the correct four digits of the year using the same steps as the ones above.
12. Once the year has been set, you will be presented with the menu to select whether your region observes Daylight
Savings Time.
13. 'DST' will be shown on the screen with a flashing 'No' beneath it (Fig E). Using 'Button 5 - Arrows' toggle between
'No' and 'Yes' and press 'Button 6 - Enter' to confirm your selection.
14. Once the date and time has been set up, you will be presented with the 'Fire' menu which can be used to switch the
product on (Fig F). Press 'Button 6 - Enter' to switch on the product.
If you wish to access the date and time setup menu at a later date.
1. Ensure the product is switched on and operating (ie. not in standby mode).
2. Press and hold 'Button 6 - Enter' on the remote until the main 'Fire' menu appears on the display (Fig G).
3. The 'Off' option will be flashing on the display. Using 'Button 5 – Arrows' navigate to the Calendar Icon.
4. Once selected, follow steps 2-14 above to set the day and time.
Fig A
Fig E
Fig B
Fig F
8
Fig C
Fig G
Fig D