Type Designation; Type Designation Sensor - ELGO Electronic EMAX-RO Series Operation Manual

8 Type Designation

8.1 Type Designation EMAX-RO
RMAX
Series/Type:
RMAX = EMAX RO measuring system
SN-number:
00 = standrad
Signal cable length:
000 = without cable (standard)
Resolution:
010 =10 µm
Interface:
SB0 = SSI Interface (25 Bit Binary code)
SG0 = SSI Interface (25 Bit Gray code)
CA0 = CANopen (DS 406)
CN0 = CAN BASIC ELGO (on request)
420 = RS422 (on request)
A20 = addressable RS422 (on request)
230 = RS232 (on request)
Bit rate:
09k6 = 9600 Bit/s-standard bit rate with RS422 (420)
19k2 = 19200 Bit/s with RS422
38k4 = 38400 Bit/s with RS422
125k = 125000 Bit/s with CAN
250k = 250000 Bit/s with CAN
500k = 500000 Bit/s with CAN
1MHz = 1000000 Bit/s with CAN
Options:
F = device address 0...F standard configuration address: 0)
Options:
---- = standard version (always with 12-pole M12 connector)
Options:
V = sealed version
Options :
A = without terminating resistor
Incremental signals:
H2N5 = incremental square-wave signals HTL with 2,5 µm resolution
H005 = incremental square-wave signals HTL with 5 µm resolution
H010 = incremental square-wave signals HTL with 10 µm resolution
H025 = incremental square-wave signals HTL with 25 µm resolution
T2N5 = incremental square-wave signals TTL with 2,5 µm resolution
T005 = incremental square-wave signals TTL with 5 µm resolution
T010 = incremental square-wave signals TTL with 10 µm resolution
SC50 = sine-cosine signals 1 Vss, 5 mm pole-pitch
*Refers to the absolute position and not on the optional incremental position
Figure 13: Type designation EMAX-RO
XX XXX XXX
AA BBB CCC
- 20 -
XXX XXXX X
DDD EEEE F GGGG
Type Designation
XXXX X X XXXX
H I JJJJ