Type Designation - ELGO Electronic PMIX Series Operating Manual

8 Type designation

PMIX
Series / Type:
PMIX
SN Number:
00 ELGO standard
01 First special version, etc.
Signal cable length in XX.X m
1,5 m standard length for LMIX/EMIX/EMIX23
1,0 m standard length forIZ14E/IZ15E/IZ16EIZ17E
Resolution / basis system:
1 0,025 mm* with LMIX sensor
2 0,01 / 0,1 mm** combined with IZ14E
3 0,01 mm* with EMIX sensor
6 0,01 / 0,1 mm** combined with IZ17E
7 0,001 mm* with EMIX23 sensor
8 0,01 / 0,1 mm** combined with IZ15E
9 0,01 / 0,1 mm** combined with IZ16E
*) at 4 edge triggering
**) selectable by parameter menu
Power supply / output levels:
00 10 ... 30 VDC / 10 ... 30 V-HTL
01 10 ... 30 VDC / 5 V-TTL line driver
11 5 VDC / 5 V-TTL line driver
99 Battery powered (for combinations with IZ display units)
Measuring length:*
0100 100 mm
0200 200 mm
0400 400 mm
0600 600 mm (other lengths on request)
*) Entire length of PMIX = Measuring length + 60 mm
Options:
D1 9 pin D-SUB connector
(ELGO standard pin assignment)
Mounting parts:
M0 with 4 holding plates (standard)
M1 with 1 swivel head „SAKB5F" and 4 holding plates
M2 with 2 swivel heads „SAKB5F"
Ordering example:
PMIX-000-01.5-1-00-0200-D1-M0
ELGO standard PMIX with a 1.5 m long signal cable, 0.025 mm resolution (at 4 edge triggering),
power supply 10 ... 30 VDC / output levels 10 ... 30 V, a measuring length of 200 mm, with a
9 pin D-SUB connector and 4 holding plates (without swivel heads).
NOTE
When ordering, please use the here described ordering code (Type Designation).
Options that are not required are filled in with „-„.
- AAA - BB,B - C - DD -
- 16 -
Type designation
EEEE - FF - G