Table of Contents
Advertisement
5 Installation and First Start-Up
CAUTION
Please read the operating manual carefully before using the device! Strictly observe the In-
stallation instructions!
In case of damage caused by failure to observe this operating manual, the warranty expires.
ELGO is not liable for any secondary damage and for damage to persons, property or as-
sets.
The operator is obliged to take and to realize appropriate safety measures.
The first start-up may only be performed by staff that has been trained and authorized by the
operator.
5.1
Operating Area
WARNING!
Do not use the device in explosive or corrosive environments!
The device must not be installed close to sources of strong inductive or capacitive interfer-
ence or strong electrostatic fields!
CAUTION!
The electrical connections must be made by suitably qualified personnel in accordance with
local regulations.
The device may be designed for switchboard mounting. During work on the switchboard, all
components must be de-energized if there is a danger of touching the energized parts!
(protection against contacts)
Wiring works may only be performed in the de-energized state!
Thin cable strands have to be equipped with end sleeves!
Before switching on the device, connections and plug connectors have to be checked!
The device must be mounted in a way that it is protected against harmful environmental
influences such as splashing water, solvents, vibration, shock and severe pollution and the
operating temperature must not be exceeded.
WARNING!
Influence of external magnets
External magnetic fields must not exceed 64 mT (640 Oe; 52 kA/m) on the surface of the
magnetic ring as this could damage or destroy the code on the tape.
- 11 -
Installation and First Start-Up
Advertisement
Table of Contents
