Subscribe to Our Youtube Channel
Related Manuals for Ingersoll-Rand 100P4
Summary of Contents for Ingersoll-Rand 100P4
- Page 1 16575425 Edition 1 December 2010 Air Pulse Tools 100P4 and 140P6 Models Maintenance Information Save These Instructions...
- Page 2 Oil Chamber Plug. Using the syringe, withdraw 1.2 cc of fluid Using a hex wrench, remove the four mechanism Cover Bolts (71) for models 100P4 and 130P4 and 1.3 cc for model 140P6. and Spring Washers (70). Lift the Mechanism Cover (68) off of the 11.
- Page 3 6. Stand the Disassembly Arbor from the Tool Kit, large end downward, on a workbench or the table of an arbor press. Insert the output end of the Drive Shaft into the central opening and either tap the Housing downward off the components or use the Pressing Sleeve in the Tool Kit to press the Housing downward off the components.
- Page 4 Assembly of the Motor, Throttle and Exhaust Element 14. Install the Cylinder (37) over the Vanes and Rotor with the end of the Cylinder having the Rear End Plate Alignment Pin (38). Make Install the Exhaust Element (9, 9A) over the Exhaust Element (9B) certain the Pin enters the hole in the face of the Front End Plate.
- Page 5 5A. For 100P or 130P: Install the Drive Shaft Seal (57) first and then Seal Back-up Ring (58) on the Drive Shaft against the hub. (Refer to Dwg. TPD1285) GREASE SEAL BACK- UP RING (Dwg. TPD1289) DRIVE SHAFT SEAL 13. Install Liner Upper Plate (45) and use a hex socket to push it (Dwg.
-
Page 6: Related Documentation
Table 2 - Impulse Tool Rebuild Tools Tool Name Part Number Tool Kit Number Model Used On Housing Cap Spanner Plug 100P4-A-HCT 100P4-99 and 130P4-99 100P4 and 130P4 Housing Cap Spanner Plug 140P6-A-HCT 140P6-99 140P6 Disassembly Arbor 100P4-B-HA 100P4-99 and 130P4-99... - Page 7 Notes:...
- Page 8 www.ingersollrandproducts.com © 2010 Ingersoll Rand...
Need help?
Do you have a question about the 100P4 and is the answer not in the manual?
Questions and answers