Advertisement
Accessing 12V Power
VEHICLE DISASSEMBLY
can't
4,
Remove (2) t-20 screws securing the lower f;I\
tray door (white arrows), then carefully lift,
~
remove and disconnect any attachements.
After removing the tray door, unscrew the
(2) t-20 screws securing the cup holder
panel (black arrows), then lift and turn
slightly to gain access to the the cavity.
Note: It is NOT necessary to completely detach
from the leather, only shift aside.
TESTING QI MODULE (MQUSM)
Testing Connection:
Before proceeding to the preparationflnstallation please test the modules
functionality by connecting the provided vehicle specific I-harness (diagram on right). Once the module is
connected, place the Qi-enabled device on the module and refer
to
the LED Status chart below for specif
ics. For technical assistance with the installation please call or visit us on the web at:
1-800-363-4490 x1 I www.scosche.com/contact.
To Vehicle 12V
Harness Connector
Note: The module can also be tested
by connecting it to aUSB to type-c
§J
·i=c::::::Jlo--if--@C:JJ
connection power source (not included).
~F===<,_J,.
~~~~~ule
~
To back of
12vsocket
IMPORTANT!
FOREIGN OBJECT DETECTION
Please follow the MAGICPLATE'" mounting instruction on pages 2 or 3 for best charging results.
Note that blocking the charging coil with anything metallic object may cause the module
to
not
work as designed.
BATTERY VOLTAGE REQUIREMENTS
The MQUSM (Qi Module) is designed to operate at voltages between 13.2-14.7. If your vehicle
does not supply sufficient voltage with the ignition OFF, you may need turn the ignition to the
ON position in order
to
operate the MQUSM. For questions about this product please contact our
Scosche tech support team at:
(800) 363-4490 ex1. 1 or www.scosche.com/contact
LEO Charging Status:
The LED indicator on the side of the mount
~
illuminates the charging status of the device. When powered ON, the
~
indicator blinks in the following order: BLUE, GREEN, BLUE.
-::;::----------,,
Standby
=
Green
'\
Charging
=
Blue
5
Advertisement
