Rigging The Halo-C To An Sm-Halo-C - EM Acoustics Halo Compact System User Manual

Page 28 of 60

7.2 - Rigging the HALO-C to an SM-HALO-C

IMPORTANT NOTE: -
ENSURE ALL PINS ARE SECURED BEFORE LIFTING
Set the rear captive link of the
HALO-C to the extended
position.
To set the HALO-C parallel to
the grid, select the 5-degree
hole. Positions lower than 5-
degrees will produce up-tilt
when required.
Locate the front link of the SM-
HALO-C into the HALO-C and
replace the quick release pin.
Locate the rear link of the
HALO-C into the SM-HALO-C
and re-insert the the quick
release pin into the HALO-C rear
link pin point.
Detailed views of these pin
positions are shown on the
following page.
HALO Compact User Manual
V7 December 2019