Rigging The Halo-C To An Fg-Halo-C - EM Acoustics Halo Compact System User Manual

Page 26 of 60

7.1 - Rigging the HALO-C to an FG-HALO-C

IMPORTANT NOTE: -
ENSURE ALL PINS ARE SECURED BEFORE LIFTING
HALO Compact User Manual
Pin the captive front link on the
FG-HALO-C to the
position and remove the quick
release pin from the rear of the
FG-HALO-C.
Set the rear captive link of the
HALO-C to the extended
position.
To set the HALO-C parallel to
the grid, select the 5-degree
hole. Positions lower than 5-
degrees will produce up-tilt
when required.
Locate the front link of the FG-
HALO-C into the HALO-C and
replace the quick release pin.
Locate the rear link of the
HALO-C into the FG-HALO-C and
re-insert the the quick release
pin into the HALO-C rear link pin
point.
Detailed views of these pin
positions are shown on the
following page.
V7 December 2019
HALO-C