Control Board And Pilot Lamps - OEM BM/2/AS Operating And Service Manual

4.6 - CONTROL BOARD AND PILOT LAMPS

(Fig 4)
The machine contains following control elements:
1. Line switch
Press this switch to power the machine; the switch
light will come on.
Press this switch again to cut the power to the ma-
chine; the light will go off.
2. Divider start button
This button is enabled when the button (5) is pressed,
i.e. when the lower rounder module is started.
Press this button to start the divider.
3. Divider stop button
Press this button to stop the divider.
4. Rounder on light
It lights up when the button (5) is pressed, i.e. when
the rounder is started.
5. Rounder start button
Press this button to start the rounder and the belt;
the light (4) will come on.
6. Stop and emergency stop button
Press this button to stop both the divider and the
rounder module.
To re-enable operation, pull out the button (6).
GB - 18
Installation and connections
FIG. 4
2 1
4
5
6
BM/2/AS
3