Cleaning And Sanitizing Procedures - Bras B-Frozen 6/1 Smart Operator's Manual

B - f r o z e n 6 & 1 0 s m a r t
mixers (inside the bowl).
The magnetic drive operates as an "intelligent clutch" able
to automatically disconnect the mixers in case they are seized
by ice or other causes.
This inconvenience can be soon noticed since an intermittent
dull noise warns that mixers are still.
In this case it is necessary to unplug immediately the
dispenser, empty the bowl and eliminate the cause of seizing.
9 The dispenser must be able to emit heat.
In case it seems excessive, check that no heating source is
close to the unit and air flow through the slotted panels is not
obstructed by wall or boxes. Allow at least 15 cm (6") of free
clearance all around the dispenser.
10 The product is for use with confectionery only.
8. 1 CLEANING AND SANITIZING
PROCEDURES
1 Cleaning and sanitizing of the dispenser are recommended
to guarantee the conservation of the best product taste and the
highest unit efficiency. This section is a procedural guideline
only and is subject to the requirements of the local Health
Authorities.
2 Prior to the disassembly and cleaning, the machine must be
emptied of product. To do this proceed as follows:
- set the power switch to I position
- set mixer/refrigeration switch(es) to I position (Soft Drink
mode)
- place a pail under each faucet and drain all product from
bowls
- set all control switches to the 0 position
8. 1. 1 DISASSEMBLING ECOAT (OPTIONAL)
1 Place the right-hand part of the recover on a surface. Place
the container inside it.(see figure 5)(see figure 6).
2 Put the left-hand part of the recover into position and make
sure that it fits into the illustrated groove. Click the two parts
figure 5
figure 6
together. (see figure 7)(see figure 8).
8. 1. 2 DISASSEMBLY
ATTENTION
Before disassembling any component, always unplug
the device from the mains.
1 To remove the lid of the container, press the top button and
slide the lid towards the front of the container.
If there is a safety lock for the lid, turn the key in an anti-
clockwise direction to release the open button (see figure 9).
2 To remove the container, push the lever upwards (see
18
figure 7
figure 8
figure 9