ABI Attachments ABI Arena Rascal Pro Setup Manual page 8

Finish Rake
The rear rake pulverizes and breaks up clumps of material
and leaves a beautiful signature finish behind in the arena.
By adjusting the rear manual jack, the Arena Rascal Pro's 1/2"
thick hardened-steel-rake, can pivot up to 90° into a variety of
finishing and grading positions. This adjustability enables the
rake to pulverize clods of material, level and finish no matter
the material consistency.
Operations
Transport the Rascal to a hard level surface to achieve the most accurate adjustments. Be sure to keep the Rascal attached
to the tow vehicle as adjustments are made. ABI does NOT recommend any adjustments be made to the Rascal unless it is
attached to a tow vehicle.
Setting up for use with scarifiers
Start by adjusting your top link to set the cutting angle. For the best ripping angle, you will want about 2" of thread on both
ends of the top link (Shown in Figure 1). This will give the scarifiers the proper angle for ripping. You can adjust them later
if you find a different angle works for your usage. If the top link is showing more thread on one side of the tip link, you will
need to disconnect that end from the Rascal and turn that end so each side is showing the same amount of thread.
Note: Use caution when disconnecting top link this as the Rascal may shift in the process.
Figure 1
Visit: abisupport.com
Figure 2
8