ABI Attachments ABI Arena Rascal Pro Setup Manual page 6

Step 5:
Locate the pin securing the gold top link to the tower
on the rear of the Rascal (refer to the
the gold pin that is holding the top link in place to keep
the tool in the upright position during shipping.
Figure 1
Step 6:
Attach the top link with the pin removed in the
previous step (refer to Figure 2). The top link should
be installed into the center hole of the rear tower just
above where the rear square jack is already installed.
You will need to slowly lower the tongue to line up the
top link up with the center hole of the tower and then
insert the pin through the lined up holes.
Note: For safety reasons, it is recommended to complete
this step with two people.
Figure 2
Visit: abisupport.com
Figure 1). Remove
Step 7:
Use the rear jack to adjust the finish rake turning it
clockwise, lowering the finish rake. This will lower
the hitch down to help match the height of your tow
vehicle hitch. As the Rascal lowers, it may become
unsteady on the pallet, so you may want to use the
front jack to lower the wheels closer to the ground
for safety.
Step 8:
Using the combination of the rear finish rake jack
and the front wheel jack, line up the Rascal hitch
to the height of your tow vehicle. Then attach the
Rascal to the hitch of the tow vehicle with the hitch
pin that was provided. After attaching it to the tow
vehicle lower the wheels as far as possible to lift the
frame and turn the back jack counter clockwise to
raise the finish rake off of the pallet. You are now
ready to drive away.
6