Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TECE TECEbox 8 cm
Summary of Contents for TECE TECEbox 8 cm
- Page 1 Sanitary systems TECEbox 8 cm TECHNICAL GUIDELINES...
-
Page 2: Table Of Contents
Contents System description Toilet module product range Cistern 8 cm Filling valve F 1 Drain valve A 3 Setting the flush volumes Throttle set Upgrade sets for TECEone Initial operation of the cistern TECEbox basic Assembly in the wall TECEbox toilet module 5-10 Assembly in the wall 5-10... -
Page 3: System Description
The TECEbox 8 cm toilet modules with cisterns can be combined both with the installation sys- tems for brick-wall construction (TECEbox basic, TECEbox and TECEbox plus) as well for dry-wall construction (TECE- box module). -
Page 4: Cistern 8 Cm
Thanks to the high technical quality standard of the filling able 8 cm cistern. By using different frames, the cistern can system (valve, hose and F1 valve) the TECE cistern is char- be installed in dry or brick-wall constructions. The TECE... -
Page 5: Drain Valve A 3
During everyday use, a considerable amount of drinking water is used to flush toilets. The intelligent solution from TECE goes a long way towards saving water. With dual- The large flush volume can be set to 4.5 / 6.0 or 9.0 litres. -
Page 6: Throttle Set
TECEbox 8 cm – Brick-wall toilet module To reduce the default large volume to 4.0 and the small Throttle set volume to 2.5 litres, the tank water level lever above the Problems with toilets not flushing correctly can be solved filling valve must also be moved to the lowest mark on the by using a throttle set. -
Page 7: Upgrade Sets For Teceone
TECEbox 8 cm – Toilet module Upgrade sets for TECEone Upgrade set for TECEbox 8 cm dry-wall module Upgrade sets are available to combine wall-mounted TECEone shower toilets with a brick-wall module or toilet module. Upgrade set for TECEbox 8 cm brick-wall-mounted cistern... -
Page 8: Initial Operation Of The Cistern
Shell construction stage This also works with the support frame for the actuation. The corner valve of the TECE 8 cm cistern is closed and pre-installed as a complete unit. The pressure can be tested without the cistern needing to be opened. The cistern only needs to be opened during the fine installa- tion phase. -
Page 9: Tecebox Basic
TECEbox 8 cm – Toilet module TECEbox basic Toilet module with cistern, ideal for floor-standing toilets and compatible with all manual TECE flush plates (exclud- ing the flush plates with IR sensor). Only for installation in a bricked-in wall. Place the module in the niche, make sure it is level and attach it using perforated rails as shown in the following diagram. -
Page 10: Tecebox Toilet Module
TECEbox toilet module Toilet module with cistern, ideal for wall-hanging toilets and compatible with all TECE flush plates (excluding the TECE- planus flush plates with IR sensor). For installation in a brick wall or in front of a solid wall. -
Page 11: Assembly In Front Of A Solid Wall
TECEbox 8 cm – Cistern Assembly in front of a solid wall Create a small cavity at least 5 mm deep behind the flush pipe so that the cistern lies full against the wall. Make sure the TECEbox module is level, open the wings on the side of the aluminium frame and attach the module to the wall. -
Page 12: Tecebox Plus Toilet Module
TECEbox 8 cm – Filling valve TECEbox plus toilet module Toilet module with sound-insulated cistern, ideal for wall-hanging toilets and compatible with all TECE flush plates (excluding the TECEplanus flush plates with IR sensor). To insulate the cistern against noise, the flush pipe housing is filled with rock wool and enclosed by 12.5 mm... -
Page 13: Assembly In Front Of A Solid Wall
TECEbox 8 cm – Drain valve The wall construction must be at least 18 mm if the actu- ation is located on the wall (A). A minimum of 30 mm is required to install the TECEsquare II (B) and when using the flush-mounted installation frame (C). - Page 14 TECEbox 8 cm – Drain valve Attach the water connection (connection R 1/2“ on cistern). The wall construction must be at least 18 mm if the actu- Brick the module in completely and follow the outline. ation is located on the wall (A). A minimum of 30 mm is...
-
Page 15: Tecebox Toilet Module
TECEbox toilet module Toilet module with cistern (8 cm deep), compatible with all TECE flush plates (excluding the TECEplanus flush plates with IR sensor). The module can be installed in front of a brick wall or in lightweight partition walls with a metal or wooden frame. -
Page 16: Repairing The Cistern
Round off the edges around the opening with a cutter knife. The TECE cistern tank is made of polypropylene. If a leak- age point is found (up to a diameter of approx. 12 mm), this can be mended using a repair set. This consists of: •... -
Page 17: Tecebox Washstand And Bidet
Insert a glue stick into the hot glue gun and apply the TECEbox washstand and bidet glue to the plastic disk (the covered area must be twice as The TECEbox modules for washstand and bidet let you large as the diameter of the opening). Only use the original implement all connections with brick walls easily. -
Page 18: Assembly For Washstand And Bidet Modules
Assembly for washstand and bidet modules The assembly phases are the same for both modules (washstand and bidet). They can be installed in front of a solid wall or installed in the wall with the help of a small niche. With the washstand module, you must set the distance between the threaded rods (minimum value 170 mm, maxi- mum value 280 mm). -
Page 19: Tecebox Urinal Flush Valve Housing
TECEbox urinal flush valve housing The flush valve housing is inserted into a slot in the wall The urinal flush valve housing with TECE valve is already and attached using a holding plate. The water connection pre-mounted on an attachment plate and can easily be and the intake for the urinal ceramics can be installed inserted into the slot in the wall. - Page 20 Install the protective shell and ensure it is aligned correctly. m in m in The bare-wall protection housing is cut flush to the wall after tiling. Please remember to follow the required wall mounting dimensions when using the corresponding urinal actuation. 5-20...
-
Page 21: Toilet Flush Plates
Toilet flush plates All manual TECE flush plates are compatible with the 8 cm cistern! TECEsquare TECEloop TECEplanus TECEnow TECEbase TECEambia The toilet flush plates shown here only give an overview of the available product range. See the whole range online at www.tece.com... - Page 22 5-22...
- Page 23 All data contained in the Technical Guidelines has been compiled with the utmost care. The correctness of the data presented cannot be guaranteed, however. TECE assumes no liability for damages resulting from the use of this information. Text and images are protected by copyright law.
- Page 24 More information on www.tece.com TECE GmbH P + 4 9 25 72 / 9 28 999 international-business@tece.com www.tece.com...
Need help?
Do you have a question about the TECEbox 8 cm and is the answer not in the manual?
Questions and answers