Presets & Control - Adamson IS Series User Manual

IS10n
Presets
The Adamson LoadLibrary
rack/245-adamson-load-library-5-0-1/file) contains presets designed for a variety of IS10n applications. Each preset is
intended to be phase-aligned within the EQ overlap region with IS-Series subwoofers.
IS10n cabinets can be installed in an array with regular IS10 cabinets, however, IS10n
cabinets cannot share the same presets with IS10 cabinets.
When cabinets and subwoofers are positioned separately, phase alignment should be
measured with suitable software.
IS10n Compact
Intended for use with an
array of 4 IS10n
Control
Array Shaping overlays (found in the Array Shaping folders of the Adamson LoadLibrary) can be recalled in the EQ
section of Lake Controller to adjust the contour of the array. Recalling the appropriate EQ overlay or preset for the
number of cabinets being used will give the standard Adamson frequency response of your array, compensating for
different low-frequency coupling.
Tilt overlays (found in the Array Shaping folders of the Adamson LoadLibrary) can be used to alter the overall acoustic
response of an array. Tilt overlays apply a filter, centered at 1kHz, which reaches the noted decibel cut or boost at the
extreme ends of the listening spectrum. For example, a +1 Tilt will apply +1 decibel at 20kHz and -1 decibel at 20Hz.
Alternately, a -2 Tilt will apply -2 decibels at 20kHz and +2 decibels at 20Hz.
Please refer to the Adamson PLM & Lake Handbook for detailed instructions on recalling Tilt and Array Shaping
overlays. https://adamsonsystems.com/support/downloads-directory/design-and-control/e-rack/205-adamson-plm-
lake-handbook/file
Adamson Systems Engineering |
(https://www.adamsonsystems.com/support/downloads-directory/design-and-control/e-
IS10n Short
Intended for use with an
array of 5-6 IS10n
IS10n User Manual
IS10n Array
Intended for use with an
array of 7-11 IS10n
Page 7