Presets & Control - Adamson IS Series User Manual

IS7
Presets
The Adamson LoadLibrary
directory/design-and-control/e-rack/245-adamson-load-library-5-0-1/file) contains
presets designed for a variety of IS7 applications. Each preset is intended to be phase-
linear with either the IS118 or IS119 subwoofers.
When cabinets and subwoofers are positioned separately, phase alignment
should be measured with suitable software.
IS7 Lipfill
Intended for use with a
single IS7
Control
Array Shaping overlays (found in the Array Shaping folders of the Adamson Load Library) can be recalled in the EQ
section of Lake Controller to adjust the contour of the array. Recalling the appropriate EQ overlay or preset for the
number of cabinets being used will give the standard Aamson frequency response of your array, compensating for
different low-frequency coupling.
Tilt overlays (found in the Array Shaping folders of the Adamson Load Library) can be used to alter the overall acoustic
response of an array. Tilt overlays apply a filter, centered at 1kHz, which reaches the noted decibel cut or boost at the
extreme ends of the listening spectrum. For example, a +1 Tilt will apply +1 decibel at 20 kHz and -1 decibel at 20 Hz.
Alternately, a -2 Tilt will apply -2 decibels at 20 kHz and +2 decibels at 20 Hz.
Please refer to the Adamson PLM & Lake Handbook for detailed instructions on recalling Tilt and Array Shaping
overlays. https://adamsonsystems.com/support/downloads-directory/design-and-control/e-rack/205-adamson-
plm-lake-handbook/file
Adamson Systems Engineering |
(http://adamsonsystems.com/support/downloads-
IS7 Short
Intended for use with an array
of 4 to 6 IS7
IS7 User Manual
IS7 Array
Intended for use with an
array of 7 to 11 IS7
Page 7