Dstream Unit Boot Sequence; Figure 1-4 Dstream Probe - ARM DSTREAM DS-5 User Manual

1.10

DSTREAM unit boot sequence

Your DSTREAM unit goes through a boot sequence when you power it up. The progress of the boot
sequence is identified by various LEDs.
The DSTREAM unit follows this boot sequence:
1. The DSTREAM backlight illuminates blue.
2. The FLASH LED flashes as accesses take place.
3. The STATUS LED flashes green and then stays illuminated, and the blue power LED on the
DSTREAM probe illuminates.
If the target is connected and powered, the TARGET LED illuminates green, and the appropriate
VTREF LED on the DSTREAM probe illuminates.
The unit is now ready for use.
Related concepts
1.4 The DSTREAM unit on page 1-13
1.5 The DSTREAM probe on page 1-16
Related tasks
1.9 Troubleshooting your DSTREAM unit on page 1-21
100955_0529_00_en Copyright © 2010–2012, 2015, 2017, 2018 Arm Limited or its
affiliates. All rights reserved.
Non-Confidential
1 Introduction to Arm DSTREAM
1.10 DSTREAM unit boot sequence
1-22