Switch The Device On; Charge The Battery - Nokia N Series Get Started

Switch the device on
1 Press and hold the power key.
2 If the device asks for a PIN
code or lock code, enter it, and
press the left selection key. The
factory setting for the lock code
is 12345.
Note: Your device has internal antennas. As with any radio
transmitting device, avoid touching an antenna unnecessarily
when the antenna is in use. For example, avoid touching
the cellular antenna during a phone call. Contact with a
transmitting or receiving antenna affects the quality of the
radio communication, may cause the device to operate at a
higher power level than otherwise needed, and may reduce
the battery life.
GPS receiver

basic phone set-up
Bluetooth technology/
wireless LAN antenna
Cellular antenna
Copyright © 2007 Nokia. All rights reserved.
Charge the battery
1 Connect a compatible charger to a
wall outlet.
2 Connect the power cord to the
device. If the battery is completely
discharged, it may take a while
before the charging indicator starts
scrolling.
3 When the battery is fully charged, the charging
indicator stops scrolling. Disconnect the charger from
the device, then from the wall outlet.
T ip: Disconnect the charger from the wall outlet when the
charger is not in use. A charger that is connected to the
outlet consumes power even when it is not connected to
the device.