Charge The Battery; Switch The Device On And Off - Nokia RM-387 User Manual

RM387_0.3_080403_clean_fcc.fm Page 10 Wednesday, April 30, 2008 12:38 PM
Remove a memory card
Important: Do not remove the memory card in the middle of an operation when
the card is being accessed. Removing the card in the middle of an operation may
damage the memory card as well as the device, and data stored on the card may be
corrupted.
1. Press briefly the power key.
2. Scroll to Remove memory
3. Open the memory card slot door.
4. Push the card gently to release it.
5. Pull the card out, and select OK.
6. Close the slot door.

■ Charge the battery

1. Connect the charger to the wall socket.
2. Connect the charger plug to the charger
connector in the device.
If the battery is completely discharged, it may
take a few minutes before the charging
indicator appears on the display or before any
calls can be made.
The charging time depends on the charger and
the battery used.

■ Switch the device on and off

Press and hold the power key.
If the device asks for a PIN code, enter the PIN code, and select OK.
If the device asks for the lock code, enter the lock code, and select
OK. The factory setting for the lock code is 12345.
For more information about access codes, see Access codes p. 16.
To set the correct time zone, time, and date, select the country you
are presently in, then enter the local time and date. See also Clock
p. 57.
card, and select OK > Yes.
10