Victron energy Color Control GX Manual page 30

Item
Periodic run
Generator start/stop -> Settings
Minimum run time
Detect generator at AC
input
Quiet hours
Reset daily run time
counters
Generator total run time
(hours)
Tank pump
Configure automatic starting and stopping of pump based on tank level(sender) information.
Control GX
Pump state
Mode
Tank Sensor
Start level
Stop level
Relay
Function
Polarity
Services
ModbusTCP
MQTT on LAN (SSL)
MQTT on LAN (Plaintext)
VE.Can port
Page 26
Color Control GX Manual
Default
No Enable - No / Yes
Run interval
Skip run if has been running for
Run interval start date
Start time
Run duration (hh:mm)
Run until battery is fully charged
0 The minimum number of minutes the generator will run for any
time that it is started, even after stop conditions.
No No / Yes - An alarm will be triggered when no power from the
generator is detected at the inverter AC input. Make sure that the
correct AC input is set to generator on the system setup page.
0 Quiet hours will prevent normal generator run conditions from
starting the generator. It is possible for some settings to specify
override values to the quiet hours ( an extremely low battery
voltage trigger to prevent a system shutdown for example)
An option to reset generator run time counters, for example if
these are used for service, or if the generator is replaced or
majorly repaired.
The total time the generator has been running since the counter
was reset.
Displays if the pump is running or not
Auto Options are Auto, On and Off. This is the manual override to the
start and stop level triggers when a tank sensor is connected.
Automatic Select the tank sensor that is used for the tank pump trigger. 'No
tank sensor' will be displayed if no tank sensor is connected or
detected,
50% The trigger point of the tank level to start the tank pump (close
the relay).
80% The trigger point of the tank level to stop the tank pump (open
the relay).
Alarm relay Select the relay function. Possible functions are 'Alarm relay',
'Generator start/stop', 'Tank pump' and 'None' (disabled).
Normally open Select the polarity of the relay on the back of the CCGX.
'Normally open' or 'Normally closed'. (Note that setting it to
normally closed increases the CCGX power draw.)
Off This setting enables the ModbusTCP service. More information
about
white paper
Whitepaper-Data-communication-with-Victron-Energy-
products_EN.pdf
On Enables MQTT on LAN - More information on MQTT is available
on Victron Community.
Off This setting is required to be enabled when connecting an
Marine MFD
VE.Can CAN-bus profile (Disabled, VE.Can & Lynx Ion BMS 250 kbit/s,
VE.Can & Can-bus BMS 250 kbit/s, CAN-bus BMS 500 kbit/s,
Oceanvolt 250 kbit/s), Send data to VE.Can, Unique device
number for VE.Can, Check unique numbers
Description
Pump auto start/stop with Color
ModbusTCP in this document and in the communications
https://www.victronenergy.com/upload/documents/
Configuration