Setting The Multi-Timer - tams elektronik Multi-Timer Manual

Multi-Timer English

8. Setting the Multi-Timer

Setting the operation mode
You can set the following operation modes on your Multi-Timer by
inserting jumpers to the solder pins JP2 to JP5:
1. time switch
2. pulse delay
3. random switch
4. start-brake-stopover switch
The Multi-Timer reads in the currently set operation mode immediately
after having been switched on. If altering the order of the jumpers after
the switching on, this has no effect until the Multi-Timer has been
switched off and on again.
The operation modes 1 and 2 have to be set on the 4 outputs
separately. Therefore you can use the Multi-Timer as a combined time
switch and pulse delay. With the operation modes 3 and 4 the setting is
valid for all four outputs.
With the operation mode 1 "time switch" you can choose whether you
want to retrigger the outputs or not. For the operation mode 4 "start-
brake-stopover switch" you have to define either a low or a high PWM
for the locomotive motor.
Page 33