Connecting The Multi-Timer; Functional Test - tams elektronik Multi-Timer Manual

Multi-Timer

7. Connecting the Multi-Timer

7.1. Functional test

Especially, when you have mounted the Multi-Timer from a kit, you
should perform a functional test before mounting it in your layout.
Connect an electric bulb with a separate power supply to output 1
(connections 1 and 2) and a push-button to switching input 1
(connection 9) as described in section 7.3 for operation mode 1.
Connect the Multi-Timer to the power supply.
Choose operation mode 1 (r) for testing all outputs, so do not insert a
jumper to any of the solder pins (→ section 8). Set a short switching
time (trim-pot as far as it will go to the left). Then check all four
outputs and switching inputs one after the other.
Caution:
!
When a component gets hot, disconnect the module from the power
supply immediately! Risk of short circuit! Check the assembly!
English
Page 27