A Appendix - Electrical Connections - Riello RL 42 BLU Installation, Use And Maintenance Instructions

A Appendix - Electrical connections
The electrical wirings must be carried out in conformity with the
regulations in force in the countries of destination, and by quali-
fied personnel.
The manufacturer cannot accept any responsibility for modifica-
tions or connections other than those shown in these diagrams.
Use flexible cables, in accordance with the regulation EN 60 335-1.
All the cables to be connected to the burner must pass through
cable grommets.
The use of cable grommets can take various forms; the following
way is just one possible solution (Fig. 31):
1 Pg 11 Three-phase power supply
2 Pg 11 Single-phase power supply
3 Pg 9 Control device TL
4 Pg 9 Control device TR
Index of layouts
1
2
References layout
3
RMO 88.53A2 operational layout
4
BERGER STA4.5 operational layout
5
Electrical connections set by installer
2
Reference layout
Appendix - Electrical connections
Sheet no.
Coordinates
27 GB
/ 1 .A 1
D10324
Fig. 31
20023224