Texsport 02853 Assembly Instructions

Thank you for purchasing this Texsport arbor. Please read and understand each step of the set-up instructions. We encourage you to
set-up this arbor at least once prior to your outdoor event, ensuring that you have a satisfactory understanding of the set-up process.
We hope you enjoy your new arbor and that it will give you many years of outdoor pleasure.
PARTS LIST:
A ..... 4 STEEL LEG POLES
B ...... 2 THICK FIBERGLASS
ROOF POLES
C ...... 4 THIN FIBERGLASS
EAVE POLES
D ..... 1 ARBOR SKIN
E ...... ARBOR STAKES, GUY ROPES
AND CLEWS
NOTE: THE SITE SHOULD BE FLAT AND
HAVE NO DEPRESSIONS THAT COULD
COLLECT RAIN WATER.
Step 1 - Spread out arbor
skin.
Step 5 - Insert each end of
the eave poles into the at-
tached molded corner joint.
ASSEMBLY INSTRUCTIONS
#02853 Montana Screen Arbor
Do not apply excessive force to this product.
D
C
Step 2 - Assemble thick
fiberglass roof poles (B) and
insert through roof sleeves
diagonally to form an "X".
Insert end of poles into cen-
ter socket of the attached
corner joint
Step 6 - This is how your
assembled roof should look.
B
Step 3 - To secure, tie poles
together at center of roof.
Step 7 - Assemble 2 sections
of the 3 section steel leg
pole (A). Insert the top of
the assembled pole section
into the attached molded
corner joint. Repeat on re-
maining 3 corners.
E
A
Step 4 - Assemble the thin
fiberglass eave poles (C)
and insert through eave
sleeves.
Step 8 - Insert the pin locat-
ed at the bottom of the ar-
bor skin (D) into the bottom
of the steel leg pole (A) to
secure legs.