Spare Parts - PCE Health and Fitness PCE-OVM 3D User Manual

7.3.1 Removing Cables
⇒ With the exception of the power supply (20, Fig. 12), remove all connectors from
the head.
⇒ Pull the HDMI cable straight out of the back and then remove it from the retaining
clip.
⇒ Remove the cable duct from the support arm.
⇒ Remove the retaining clip.
⇒ Remove the cable tie at the foot end of the cable duct. Make sure that no cables
are damaged.
⇒ Pull the desired cable out through the ribs of the cable duct.
7.3.2 Inserting Cables into the Cable Duct
Two retaining clips are designed as insertion aids for inserting new cables.
⇒ Place the cable duct on a flat surface.
⇒ Use the insertion aid to grab the cables that are already in the cable duct.
⇒ Press the insertion aid together completely.
⇒ Push the insertion aid 3 or 4 ribs deep into the cable duct with the tapered end first.
⇒ Feed the plug of the cable you want to insert through the insertion aid and press the cable into the cable duct that
has been opened by the insertion aid.
Make sure that the plug is inserted from the correct side.
⇒ Hold the cable duct securely behind the insertion aid.
⇒ Pull the insertion aid and the plug of the cable to be inserted through the cable duct to the other end. Make
sure that the plug does not slip out of the insertion aid.
⇒ Remove the insertion aid.
⇒ Pull the cables through so that they protrude approx. 20 cm (7.9 in) past the cable duct at the side of the
PCE-OVM 3D head so that the head is not hindered when it pivots.
⇒ On the opposite side of the cable duct, secure the cables to the cable duct with cable ties so they cannot slip.
⇒ Clip all the retaining clips onto the cable duct and secure the cable duct to the support arm.
Retaining clips designed as an insertion aid fit on the upper part of the support arm; the other clips
go on the lower part.
⇒ Insert the cables into the head.
⇒ Plug the HDMI cable into the retaining clip and then plug it straight into the socket.
⇒ Reconnect the other side of the cables.
Multiple cables can also be fed through together.

7.4 Spare Parts

If you should need any spare parts for the PCE-OVM 3D, please contact our technical support at +49 23 8098 7035
or info@pce-instruments.co.uk.
✓
Fig. 32
23