PCE Health and Fitness PCE-OVM 3D User Manual page 10

4.3.2 Mounting the Head
Four washers are needed for mounting the head (see Fig. 7).
Three small washers (golden/black/golden) have already been threaded
onto the fastening screw (31) in the correct sequence. The large washer is
attached to the head with an adhesive strip with a red end.
⇒ Remove the adhesive tape with the red end.
⇒ Loosen the fastening screw (31) on the support arm.
⇒ Attach the fastening screw with all three small washers through the
adapter of
the head.
⇒ Make sure that the three small washers (golden/black/golden) and the
large
washer are in the correct order as shown in the figure.
⇒ Insert the adapter with the fastening screw and tighten the fastening screw until
the head no longer tilts downward.
4.3.3 Positioning the Monitor
⇒ Position the monitor so that it is directly in the field of view. The distance to the observer should be between 50
and 70 cm (19.69 – 27.56 in).
⇒ Align the monitor (tilt, rotate using stand) so that the viewing direction is perpendicular to the monitor in all
planes (Fig. 8/9).
Fig. 8
4.3.4 Adjusting the Clamping Force
In order to achieve a stable position of the head, the clamping forces of the three joints can be adjusted individually.
• Support arm
-
Fasten the screw at the head (32).
-
Middle clamping screw (33)
-
Clamp screw on base part (34)
• Swiveling the head right/left
- Clamping screw (35) with the included tool (9, Fig. 1)
• Height adjustment
- Clamping screw (36) with the included tool (9, Fig. 1)
Fig. 9
10