Operation; Switching On; Adjusting The Monitor; Adjusting The Focus - PCE Health and Fitness PCE-OVM 3D User Manual

5 Operation

5.1

Switching On

⇒ Switch on the monitor by pressing the power button (8, Fig.1).
⇒ Switch on the head using the power switch (7, Fig. 1).
♦ The lighting starts operation.
♦ After about 20 seconds, an image appears on the monitor.
The cone of light on the table top defines the area whose center is captured by the optics.
5.1.1 Stand-By
If there is no movement below the head for more than 10 minutes and the mouse has not been moved for more than
10 minutes, the lighting and the monitor output are switched off. The monitor's power button (8, Fig. 1) flashes in this
case. The stand-by mode is ended when the mouse is moved or movement takes place in the detection range of the
optics.

5.2 Adjusting the Monitor

In most cases, the monitor can be used with its basic settings.

5.3 Adjusting the Focus

There are two options for focusing the image:
•
Coarse adjustment by moving the head with the support arm
•
Fine adjustment through height adjustment (6, Fig. 1)
The amount of force required for the movement of the support arm, head, and height adjustment can be adjusted
using the fastening and clamping screws, see Chapter 5.4. The following procedure is recommended:
⇒ Align the head parallel to the table.
⇒ Place the object on the desk pad within the cone of light.
⇒ Set the head to the middle of the height adjustment.
⇒ Set the head on the support arm so that the object can be seen on the monitor and, if necessary, adjust the height
adjustment.
This allows you to quickly correct the focus for objects with different heights.

5.4 System Settings

The current settings of the system are displayed on the monitor at the bottom left.
As soon as the mouse is moved, the monitor displays the available settings and with which element of the mouse the
setting can be changed.
12