Product Specifications - AMX DAS-T0804-SIG Operation/Reference Manual

Tango Series Audio Controllers

Product Specifications

The following table provides technical specifications for the Tango Audio Controllers. Unless otherwise
noted, these specifications apply to both the DAS-T0804-SIG and DAS-T0808-SIG models.
Tango Audio Controllers Product Specifications
Models Available:
Stereo Output:
Power:
Zone Support:
Stereo Amplifiers:
SRS/WOW
Front Panel Components:
• Light Bar
• LEDs
• Function/Navigation Buttons
• IR Receiver
• LCD Display
Rear Panel Components:
• Power Switch & Receptacle
• Paging In/Out Ports
• RJ 45 Port
• RS-232 Port
• AM/FM Antenna Inputs
• Audio Inputs
• Audio Outputs
• IR Outputs
• Zone Outputs
• Expansion Port
Dimensions (HWD):
(including feet)
2
• DAS-T0804-SIG Tango 8-Source, 4-Zone Audio Controller (FG1103-01)
• DAS-T0808-SIG Tango 8-Source, 8-Zone Audio Controller (FG1103-02)
25 Watts/CH stereo (20Hz to 20Khz @ .1% THD)
960W max (Actual average usage = 300W)
DAS-T0804-SIG - Four independent audio Zones.
DAS-T0808-SIG - Eight independent audio Zones.
• Each Zone is protected thermally.
• Zone grouping.
• Independent Volume, Bass, Treble, Balance and SRS
zone.
• 40 Watts/CH stereo amplifiers (20Hz to 20Khz @ .1% THD).
• Amplifiers are protected from overload and thermal runaway.
®
: Standard SRS/WOW
zones.
Note: SRS/WOW is a registered trademark of SRS labs, Inc.
Blue light bar indicates power status.
Blue LEDs indicate level status.
5 pushbuttons allow for front panel programming, selection of sources, tun-
ing AM/FM radio stations, or Sirius satellite radio stations (when equipped
with the optional Sirius and/or AM/FM Tuner Card).
This is where you must aim the remotes from your audio source components
so the Controller can learn and emulate those commands.
Displays information necessary during the programming steps and afterward
is the display to indicate information about the source input and zone activity.
The master power switch will remain in the ON position normally.
RCA jacks to connect to Paging devices (any audio input can be used as a
paging device). The Paging device connects to the Controller via the "Paging
In" connector. The "Paging Out" connector is used to carry the page to Zone
Expander(s).
Ethernet Port for future expansion
DB9 connector allows the Tango Audio Controller to receive Controller Com-
mand Messages and provide status messages. This port is intended
primarily for troubleshooting purposes.
Connections for the AM and FM Antennas.
Stereo Inputs, 47K impedance, buffered.
Stereo Looping Outputs, buffered.
• DAS-T0804-SIG: Four IR 3.5mm mono output jacks.
• DAS-T0808-SIG: Eight IR 3.5mm mono output jacks.
• DAS-T0804-SIG: 4 zone output connectors (connect to Metreau keypads)
• DAS-T0808-SIG: 8 zone output connectors (connect to Metreau keypads)
RJ-11 Port connects main Tango Controller with Tango Zone Expanders.
• 4" x 17" x 13.5"
• 10.16 cm x 43.18 cm x 34.29 cm
®
audio enhancement technology by SRS Labs, on all
Tango Series Audio Controllers
®
controls in each