Yale Assure Lock SL YRD256 Installation And Programming Instructions page 16

Definitions
All Code Lockout Mode: This feature is enabled by the Master code. When enabled, it
restricts all user (except Master) PIN code access. When attempting to enter a code while the
unit is in Lockout, the RED locked padlock will appear on the screen.
Automatic Re-lock Time: After a successful code entry and the unit unlocks, it will
automatically re-lock after thirty (30) seconds.
Inside Indicator Light: Located on the interior escutcheon. Shows active status (Locked) of
lock and can be enabled or disabled in the Advanced Lock Settings (Main Menu selection #3).
Language Setting Mode: Choosing English (1 ), Spanish (2) or French (3) becomes the
(default) setting for the lock's voice prompts.
Low Battery: When battery power is low, the Low Battery Warning indicator flashes RED.
If battery power is completely lost, use the 9Volt battery override. To use the 9V battery
override apply 9V battery, in either direction, to terminals below the touchscreen for backup
power option. Wake up the lock and enter your pin code to unlock the door.
Master PIN Code: The Master PIN code is used for programming and for feature settings.
It must be created prior to programming the lock. The Master code will also operate
(unlock/lock) the lock.
Network Module Setting: With the optional Network Module installed, this setting becomes
available thru the Main Menu (7) and allows the lock to connect with a network controller.
One Touch Locking: When the latch is retracted, activating the keypad will extend the latch
(during Automatic Re-lock duration or when Automatic Re-lock is disabled). When One-Touch
Re-lock is not in use (disabled), any valid PIN code will re-lock the lock.
Previous: While in Menu Mode, pressing this icon cancels the current operation and returns
the user to the previous step.
Privacy Mode: Privacy mode is disabled by default. Enable Privacy mode by pressing the
privacy button for 4 seconds to put the lock in do-not-disturb mode (all pin codes are
disabled).
Shutdown Time: The unit will shutdown (flashing RED) for sixty (60) seconds and not allow
operation after the wrong code entry limit (5 attempts) has been met.
Tamper Alert: Audible alarm sounds if attempting to forcibly remove outside lock from door.
User PIN Code: The User code operates the lock. Maximum number of user codes is 250 with
Network Module; without Network Module, maximum is 25 user codes. Note: When deleting
User PIN code(s), screen will display User Number (not PIN code) being deleted.
Volume Setting Mode: The volume setting for PIN code verification is set to Low (2) by
default; otherwise it can be set to High (1) or SIient (3) for quiet areas.
Wrong Code Entry Limit: After five (5) unsuccessful attempts at entering a valid PIN code,
the unit will shut down and not allow operation.