Pumpkin Soup; Troubleshooting - Bosch MUZ45MX1 Instruction Manual

en Troubleshooting
Red fruit pudding
– 300 g fruit (pitted sour cherries,
raspberries, black/red currants,
strawberries, blackberries)
– 75 ml sour cherry juice
– 75 ml red wine
– 60 g sugar
– 1 sachet vanilla sugar
– 1 tbsp. lemon juice
– 1 generous pinch cloves (ground)
– 1 pinch cinnamon (ground)
– 4 sheets gelatine
■ Soak the gelatine in cold water for
approx. 10 minutes.
■ Bring all ingredients (except the
gelatine) to the boil.
■ Squeeze out the gelatine and melt in the
microwave, but do not cook.
■ Blend the hot fruit and gelatine at setting
1 for approx. 1 minute.
■ Pour the pudding into small bowls rinsed
out with cold water and chill.
Do not process more than 400 ml of hot
liquid in the blender jug!
Tip: Red fruit pudding tastes good with
w hipped cream or vanilla sauce.

Pumpkin soup

– 320 g yellow-flesh pumpkin
– 100 g potatoes
– 500 g vegetable stock
– 1 onion
– 1 clove garlic
– Ground pepper and salt
– 15 g butter
– 1 tbs extra virgin olive oil
– 4 basil leaves
– 1 sage leaf
– 1 sprig parsley
– 1 sprig thyme
– 1 sprig marjoram
– ¼ tsp ground cinnamon
– Grated Parmesan to taste
■ Cut the pumpkin into slices and remove
the peel and pips. Cut the pumpkin into
small pieces.
■ Peel the potatoes and also cut into small
pieces.
12
■ Peel the onions, chop finely and fry
gently in a frying pan with butter, olive oil
and chopped garlic.
■ Add the pumpkin and pieces of
potato and steam until soft, stirring
continuously. Gradually pour in the
vegetable stock and add the bouquet
garni.
■ Leave to simmer on a low heat for
approx. 25-30 minutes and add more
stock if required.
■ Take out the bouquet garni.
■ Add salt and pepper to taste and finish
with a pinch of cinnamon and a dash of
extra virgin olive oil.
■ Pour 400 ml of the soup into the blender
jug at a time and purée.
Do not process more than 400 ml of hot
liquid in the blender jug!
■ Serve with finely grated Parmesan
sprinkled on top.

Troubleshooting

Fault:
Liquid is leaking from the blender at the
blade holder.
Remedy:
■ Is the seal fitted to the blade insert?
■ Check the seal is fitted properly.
Important: If a fault cannot be eliminated,
please contact customer service.
Subject to change.