Advertisement
5. Error handling
When the unit has error or protection, "
for 3 seconds to enter check status and then press the "▲" or "▼" key to check the unit
of 0-15#. If the "error" icon is on, it means the corresponding unit has error or protection
at that time. The last 3 error or protection codes of the unit can be checked. The error
icon will disappear if the error or protection is cleared.
Error code list (when the wire controller set to 1).
Conflict model error
Communication error
Sensor error of water inlet temp
Sensor error of condenser pipe temp(A)
Sensor error of condenser pipe temp(B)
Sensor error of water outlet temp
Sensor error of water temp.in tank(Reserve)
dF:defrost operation
d0:oil return operation
dF and d0 are normal operation,not error
" icon will flash. Press and hold "SET" key
EEPROM error
Outdoor unit or MS error
Cycle water flow detection error
No address code
Remote shutdown lock
Anti freeze protection
NOTE
Table 5-1
Advertisement
