2) Set the stop and restart temperature
difference (Valid when the wire controller
is set to 5)
Continuous press "FUNCTIONS" key for 4
times to enter temperature difference
setting, the LCD will display "diFF". Press
the "▲" or "▼" key to adjust the
temperature difference, press "OK" key or
wait for 7 seconds to confirm and back to
the main page. During setting process
pressing "CANCEL" key to exit without
saving. The range of temperature
difference is 2-10 degree.
Check the stop and restart temperature
difference setting: Press "◄" or "►" key
under main page to check the difference
value which has been set.
RUN
HEAT
WATER
TEMP.
MODE
FUNCTIONS
Press
2 times
(Long press 3s
for cancelling timing)
ONLINE
QUANTITY
(Long press 3s
for unlocking)
Fig.4-3
3) Timing setting: 3 timing periods can be
set on the wire controller: Timer 1,
Timer 2, Timer 3. These 3 timers can
control the main unit to be turned ON
and OFF 3 times at most during a day.
Setting method: press "
key under main page three times to
enter timing setting. Then the LCD will
display as the following:
TIMER
ON
RUN
HEAT
WATER
TEMP.
TIMER
ON
MODE
FUNCTIONS
Press
3 times
(Long press 3s
for cancelling timing)
FUNCTIONS
Fig.4-4
CYCLE
ONLINE
QUANTITY
(Long press 3s
for unlocking)
Fig.4-5
"