Advertisement
4.2 Setting operating modes and parameters
Press "FUNCTIONS" key to enter the operation mode and parameters setting. The setting contents
will change as the following order each time the key is pressed:
NOTE
The setting options in the dotted line frame
are not general setting. The wire controller
automaticly
judge the needed setting according to the
main unit model.
1) Setting water temperature: Press the "▲" or
"▼" to adjust the water temperature after
the controller is powered on. Or press "SET"
key once when "SET WATER TEMP" is
displayed on the LCD and then press "▲" or
"▼" to adjust water temprature.
Water temperature setting check: To check
the water temprature setting vaule, press
the "◄" or "► " key under the main
page(the page displayed after the controller
is powered on).
MODE
HEAT
MODE
(Long press 3s
for cancelling timing)
TEMP. DIFFERENCE
CYCLE
ONLINE
QUANTITY
RUN
SET
WATER
TEMP.
TIMER
FUNCTIONS
Press one
time
(Long press 3s
for unlocking)
Fig.4-2
Advertisement
