General Recommendations And Safety Regulations - ELEKTRA SIXTIES Instruction Manual

B GENERAL RECOMMENDATIONS
AND SAFETY REGULATIONS
1 This booklet is an essential and integral part of the product
and must be given to the user.
It contains basic safety instructions that must be followed for
the installation, operation and maintenance of the appliance.
Save these instructions.
2
After having unpacked the appliance, make sure it is intact.
If in doubt, do not use the appliance and contact a qualified
engineer. The packing elements (plastic bags, polystyrene
foam, nails, etc.) should not be left within reach of children
since they are potential sources of danger.
3
The appliance should be installed by a qualified engineer
according to the manufacturer's instructions and in compliance
with current safety regulations.
Incorrect installation could cause injury to persons or animals
and damage to property, for which the manufacturer cannot
be held liable. The company Elektra declines any and all
responsibility for tampering or interventions carried out by non
authorized persons. Such intervention automatically renders
the guarantee null and void
The appliance must be installed only in places where its use
and maintenance can be carried out by qualified personnel.
Before carrying out the electrical connection of the appliance,
check that the mains electricity supply corresponds to the
data given on the rating plate.
The rating plate is located on the front of the espresso coffee
machine (Sixties and Classic models) or inside the cup heater
tray (Belle Epoque models).
The wiring diagram is given on an adhesive tag applied to the
end of the power cable.
8
.
This appliance is only electrically safe when it has been
connected to an efficient grounding system in compliance
with current safety regulations
Make sure that this fundamental safety requirement has
been observed and if in doubt request a thorough check of
the system by a qualified electrician.
The manufacturer cannot be held liable for any damage that
may be caused by failure to ground the appliance.
If the appliance does not have power cable with plug,
at installation the appliance should be connected to the
electricity supply through a multipolar linked switch having a
contact separation of at least 3 mm in all poles, in compliance
with current safety regulations.
Check that the current carrying capacity of the system is
adequate for the maximum rated output of the appliance
as indicated on the rating plate and, in particular, that the
section of the cables is adequate for the power absorbed
by the appliance. Unwind the whole power supply cable to
prevent dangerous overheating.
It is forbidden the use of adapters, multiple current taps or
extension cables.
This appliance should not be installed in kitchens.
4
For the operations of connection to the water supply network,
comply with the provisions in this manual.
5 This appliance should only be used for the purpose for
which it was designed. Any other use is to be considered as
unsuitable and therefore dangerous.
The manufacturer cannot be held liable for any damage or
injury caused by improper, wrong or unreasonable use.
.
9