Finishing The Configuration - SOLAR controls WATTrouter ECO User Manual

WATTrouter ECO - user manual
6. In case of usage of more wireless peripherals, repeat this procedure from point one for each one. Do
not connect new stations to power line at the same moment, because otherwise the identification of
new station will be impossible.

FINISHING THE CONFIGURATION

After setting up the device according to previous chapters, the controller is fully configured. You may save the
preset configuration by pressing the Save button or you may load it at any time by pressing the Open button.
This way you may create several different configurations and monitor them for some time and determine
which one provides better utilization of energy self-consumption in your facility or household.
After you have completed the settings then in case of manipulating within the distribution box turn off entire
distribution box, remove the USB cable and turn on the distribution box again.
Tip: In order to maintain continuous monitoring the controller can be kept connected via USB. If you want to
use permanent USB connection, then it is recommended using a suitable USB isolator or USB connection
extender via Ethernet (for example Silex 3000GB).
How to fit and setup the device
www.solarcontrols.cz
Page 29 from 66