Installation
59
(for qualified installers only)
8. Install the LP pilot orifice following the instructions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace the pilot
hood, tightening the pilot hood until it is snug (do not over-tighten).
MV Version
GSB2/GSR2
Version
© Travis Industries
4/22/21 - 1458
PB 72 MV/GSB2/GSR2 Install