In Case Of Errors - American Megatrends Baby Voyager User Manual

Step 11 Perform Initial Test and
Continued
Configuration,
I n C a s e o f E r r o r s I n C a s e o f E r r o r s
If the system beeps during POST (power on self test), a serious
problem exists with the system configuration or hardware. The beeps
are part of a Beep Code (see page 35) that almost always indicates a
bad component or that the system must be reconfigured. If a beep
code sounds, make sure the affected part is properly seated and
connected.
Error messages can also appear on the monitor. Displayed messages
are described on page 36. Recheck the system configuration or the
connections to assure that the installation procedures were followed.
AMI Baby Voyager User's Guide
33