Table of Contents
Advertisement
Step 6 Test and Configure
Start the Test
BIOS Errors
Configure the System
Apollo-II PCI Pentium ISA Motherboard User's Guide
34
Review the following points before powering up:
make sure that all adapter cards are seated
properly,
make sure all connectors are properly
installed,
make sure the CPU is seated properly,
make sure there are no screws or other foreign
material on the motherboard,
plug the system into a surge-protected power
strip, and
make sure blank back panels are installed on
the back of the chassis to minimize RF
emissions.
Plug everything in and turn on the switch. If there
are any signs of a problem, turn off the unit
immediately. Reinstall the connectors. Call
Technical Support if there are problems.
If the system operates normally, a display should
appear on the monitor. The BIOS Power On Self
Test (POST) should execute.
If POST does not run successfully, it will beep or
display error messages. Beeps indicate a serious
problem with the system configuration or
hardware. The Beep Code indicates the problem.
AMIBIOS Beep Codes are defined in the AMIBIOS
Technical Reference. Make sure the affected part is
properly seated and connected. An error message is
displayed if the error is less serious. Recheck the
system configuration or the connections.
Run WINBIOS Setup. You must enter the
requested information and save the configuration
data in CMOS RAM. The system will then reset,
run POST, and boot the operating system. See page
38 for information on configuring the computer.
Advertisement
Table of Contents
