Step 7 Connect Cables; Connect The Reset Button; Connect Cables - American Megatrends Baby Voyager User Manual

Step 7 Connect Cables

When connecting chassis connectors to the motherboard, make sure
to connect the correct end. Most connector wires are color-coded.
Match the color of the wires leaving the switch or LED to the same
pin on the connector end. There may be more than one connector
with the same color-coded wires. If so, follow the wire to the switch
or LED. Pin 1 of all connectors is labeled to identify the pin orientation
when plugging in cables. See the following graphic.
The following cables should be connected to the motherboard from
the chassis:
• Reset Switch cable to J12.
• Speaker cable to J13.
• Keyboard Lock cable to J15.
• Turbo LED cable to J23.
• External Battery Connector to J2.
C o n n e c t t h e R e s e t B u t t o n C o n n e c t o r C o n n e c t t h e R e s e t B u t t o n C o n n e c t o r
J12 is a 2-pin single-inline berg. When this button is pressed, the
system performs a hard reset. Pin 1 is ground and Pin 2 is Hard
Reset.
Chapter 2 - Installation
22
L o c a t i n g P i n 1 L o c a t i n g P i n 1