Step 8 Install Floppy Drive; Install Floppy Drive - American Megatrends Baby Voyager User Manual

Step 8 Install Floppy Drive

P 6 F l o p p y D i s k D r i v e C o n n e c t o r P 6 F l o p p y D i s k D r i v e C o n n e c t o r
P6 is a 34-pin dual-inline berg. Connect the cable from the floppy drive
to P6. The onboard floppy controller cannot be used if a hard disk
adapter card with floppy controller is installed. The following graphic
shows the P6 floppy connector and 34-pin cable.
Pin 1 of Connector/Cable
The AMI Baby Voyager supports 3½" and 5¼" floppy disk drive in low
density (360 KB/720 KB) and high density (1.2 MB/1.44 MB). Up to
two floppy disk drives can be connected to the interface. The
connecting cable is a 34-pin ribbon connector with two 34-pin edge
connectors for connection to the floppy disk drives. There should be a
small twist in the cable between the floppy connectors, and the last
(end) connector should be connected to the Drive A: floppy.
AMI Baby Voyager User's Guide
27