Spectrum 55496 Assembly Instructions

Assembly Instructions Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt. To
report information regarding missing parts or damage, to purchase parts or acces-
sories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
(1) 0140345
Keyboard Tray
(1pr) 050092
12" Slide set
Note: For CORE Lectern installations only, (12 8-32 x 1/2" PH thread-cutting
screws, (8) #8 x 5/8" PHSM screws and (8) 8-32 locknuts are used.
1. Assemble slide brackets 1. Assemble slide brackets
1. Attach the 'L' brackets to each outer slide with screws (included
with slides). The brackets need to be attached "inboard" (facing
each other). Figure 1.
• For Freedom XRS / CORE Lecterns, multiple height positions /
mounting holes are available with the brackets-use the same hole
position on all four brackets.
• For Pivot Premiere Lecterns, use the tallest position on all four
brackets.
2. Tighten the bracket screws securely.
3. Separate the inner from the outer slides using the black levers.
4. Raise the lectern up all the way and unplug the power cord.
(14) 0100167
8-32 x 1/2" PH
thread-cutting
screw
(8) 037542
#8 x 5/8" PHSM
(8) 029019
8-32 Locknut
Note: On Freedom XRS and Pivot Premier installations, the 'L' brackets can be
adjusted to provide varied keyboard heights-the keyboard tray may protrude up to
a maximum of 3.9" [10 cm] below the worksurface. If the lectern is used for ADA
use, a higher adjusted worksurface will be necessary to provide ADA leg clearance.
Pull-out Keyboard Tray Pull-out Keyboard Tray
55496 55496
'L' Bracket
Screw
(included with slides)
"
3/8
Inner slide
'L' Bracket
Outer slide
Figure 1
0191446R1 Page 1 of 3