Installing The Flight Battery - Horizon Hobby BLADE 150S Smart Instruction Manual

Installing the Flight Battery

1
1. Lower the throttle stick to the lowest position.
2. Power ON the transmitter.
3. Center all trims. The trims should always remain in
the center position. If you feel the trims need to be
adjusted please perform the trim flight procedure
located towards the back of this manual.
4. Attach the hook material to the helicopter frame and
the loop material to the flight battery.
5. Install the flight battery on the helicopter frame.
Secure the flight battery with the hook and loop strap.
NOTICE: If the flight battery hook and loop strap is pulled
too tight, it may result in a vibration or the tail rotor may
drift during flight. If you experience either of these issues,
loosen the strap slightly and fly again.
CAUTION: Connecting the battery to the ESC with
reversed polarity will cause damage to the ESC,
the battery or both. Damage caused by incorrectly
connecting the battery is not covered under warranty.
LED Indicator on Flight Controller
LED Indicator on FC
Red Solid
Yellow Flash
Slow Green Flash
Slow Red Flash
Red Solid and Yellow Flash
2
AR6250MHX waiting for receiver connection, system will not initialize
Calibration Error, FC not level or is being moved during calibration
3
If you experience issues during initialization, refer to the
Troubleshooting Guide at the back of the manual.
CAUTION: Always disconnect the Li-Po
battery from the aircraft when not flying to
avoid over-discharging the battery. Batteries discharged to
a voltage lower than the lowest approved voltage may
become damaged, resulting in loss of performance and
potential fire when batteries are charged.
WARNING: Always activate throttle hold and wait
until the main rotor blades and tail rotor stop
spinning before handling the model.
The throttle trim on the transmitter must remain at the
center position. Raising the throttle trim above center
may cause the main and tail motors to begin spinning.
Indicator Description
until connected
Calibrating
Ready to Fly
Failsafe Active
5
EN